Components
LoRa Module
Antenna
USB-USB-C Cable
GL-iNet Gateway
USB-C Power Supply
Step 1: Assemble the LoRa Module with its Antenna
Attach the Antenna
Screw the antenna onto the LoRa module. This step is essential to ensure the proper functioning of the signal.
Connect the USB-C Cable
Plug the USB-C end of the cable into the LoRa module, leaving the other end (standard USB) free.
Step 2: Assemble the GL-iNet Gateway
Connect the USB Cable
Plug the free USB end (from the previous step) into the GL-iNet gateway.
Power the Gateway
Plug the USB-C power cable into the dedicated port on the gateway to turn it on and recharge its built-in battery.
⚠️ Imperatively use a standard 5V / 2A power adapter. Any other adapter could cause malfunction.
Wait for All Status Lights
The gateway takes about 3 minutes to fully start up.
Note:
At any time, you can turn off the gateway by pressing the power button for 5 seconds to turn it off or on.
Precautions
Never remove the antenna from the LoRa module when it is connected to the gateway via USB. This could damage the hardware.